skip to main text

Print settings

Select this setting item from Printer settings in (Setup).

  • Reduce ink volume

    Adjust ink volume when ink on the printed surface of printed materials comes off or smudges when touched immediately after printing.

    Note

    • Ink volume can be set for each type of paper used.

  • Prevent paper abrasion

    Use this setting only if the print surface becomes smudged.

    Important

    • Be sure to set this back to OFF after printing since it may result in lower printing speed or lower print quality.

  • Adjust horizontal print position

    Adjusts the print position when the left/right margins are not aligned.

    You can adjust the left/right margins in increments of 0.004 in. (0.1 mm) between -0.12 in. (-3 mm) and +0.12 in. (+3 mm) centered on the horizontal center of the paper.

    Important

    • When using A4/Letter sized paper, the amount of adjustment that can be made is limited. You cannot make adjustments greater than this limit.

  • Print target for plain paper

    Select Text only or Text and photos for plain paper printing.

    Note

    • As print results, if you are conscious of unevenness or textures of granularity, select Text and photos.

  • Print charts and diagrams vividly

    Use this setting when you want to print charts and diagrams in documents vividly on plain paper.

    This feature gives preference to printer driver settings.

    When you want to give preference to printer settings, select Use Printer Settings in the Print charts and diagrams in documents more vividly (plain paper) in Print Options dialog box in the printer driver settings below.

    Note

    • This feature will be implemented with the following settings.

      • Plain paper

      • Color printing

      • Size is a template size or a user-defined size within the range of a template size

      * The feature may not be implemented even when the above settings are selected, depending on other setting details.

    • Processing may differ depending on settings and may result in the same data having different tones. Turn this setting OFF if you want to avoid differences in tone.